Optical Beam System
Optical Beam with Counter: (Specifications)
- Photoelectric Sensor
- Circuit Type SPDT
- Sensing Range 9 to 32.8 Feet
- Contact Current Rating 3 Amperes
- Response Time 15 Milliseconds
- Height 3.5 Inches, Depth 2.95 Inches, Width 1.02 Inches
- Maximum AC Voltage Range 24-240 Volts
- Maximum DC Voltage Range 12-240 Volts,
- Retroreflective
- Time Delay, includes right angle mounting bracket
Photoelectric Sensor, Circuit Type SPDT, Sensing Range 9 to 32.8 Feet, Contact Current Rating 3 Amperes, Response Time 15 Milliseconds, Height 3.5 Inches, Depth 2.95 Inches, Width 1.02 Inches,
Maximum AC Voltage Range 24-240 Volts, Maximum DC Voltage Range 12-240 Volts, Retroreflective, Time Delay, includes right angle mounting bracket
Item
Retroreflective, General Duty, Time Delay
Use with or without Reflector
Circuit Type SPDT
Height (In.) 3.5
Depth (In.) 2.95
Width (In.) 1.02
Volts Range Max. AC 24-240
Volts Range Max. DC 12-240
Sensing Range (Ft.) 9.8
Type Conduit Connection
Max. Amps 3
Response Time (ms) 15
Operating Procedures: Photoelectric Sensors
OPTICAL BEAM SYSTEM
Adjustment
|
Item Model |
Through-beam Models |
Retro-reflective Models |
Diffuse-reflective Models |
|
E3JM |
For a E3JM with the timer function, the indicator will be lit when incident light is received while the mode is switched to Light-ON, and the indicator will be lit when light is interrupted while the mode is switched to Dark-ON. |
The indicator of the Retro- reflective Model with the timer function is lit in the same way as for the Through-beam Model. |
The indicator of the Diffuse-reflective Model with the timer function is lit in the same way as for the Through-beam Model. |
|
E3JM, E3JK Common items |
Move the emitter and receiver horizontally and vertically, and locate them to the center of the range in which the receiver indicator is lit. |
As with the Through-beam Model, adjust the reflector and Sensor. Since the directional angle of the E3JM and E3JK Retro-reflective Models is 1 to 5 degrees, pay careful attention when adjusting the Sensor. |
Sensing object is present. Sensing object is not present. Setting Back- ground
(A) Operation (A) (C) Release (A) (C) (B) Operation MIN MAX MIN MAX MIN MAX Sensitivity Sensitivity Sensitivity (1) If a sensing object is present as shown above, turn the sensitivity adjuster clockwise to increase the sensitivity. Point (A) is where the indicator is lit. (2) Remove the sensing object and turn the adjuster clockwise. Point (B) is where the indicator is lit by background objects. (3) Turn the adjuster counterclockwise to decrease the sensitivity, starting from the point (B). Point (C) is where the indicator is lit. (4) The center point between the point (A) and point (C) is the optimum position. If the indicator is not lit by the background object at the maximum sensitivity, set to the center point between the point (A) and the maximum sensitivity. · The sensitivity adjuster may be damaged if an excessive force is applied. |
